Main GA-60X cannot detect P3 1400/512/133

[juncon27]

J'ai ce mainboard : l'appui p3 d'GA-6OX.It 1.4 gigahertz, mais mon mainboard ne peut pas le détecter. Veuillez m'aider. Mon Français très pauvre, je suis si désolé.

How to set JP? This is GA-60X Manual:
http://www.gigabyte.com.tw/Support/M...uctName=GA-6OX

[Lissyx]

Try in english, I think it'll be easier for everyone

[Neo_13]

I think we should burn the online translators...

[juncon27]

I'm so so so so sorry.

That's all I mean:

I have GA-60X and a chip P3 1.4 Ghz. This main use P3 1 Ghz ok, but when I use P3 1.4 Ghz it cannot detect. I don't know how to set JP on the main. I don't know much about hardware. Please tell me how to set JP on this main for chip 1.4 Ghz.

My English is poor, too. I'm so sorry about this.
Thankyou very much.

[jihef]

First try to set all the switches of SW1 to off, if it doesn't work try what's below. By the way save the original setting of SW1, it could be useful.

You need to know te speed of your RAM it should be 133 or 100 MHz, maybe 66Mhz. Then have a look at page 7 of the manual. You must place SW1 like the line where you have CPU at 133 and SDRAM at the speed of your memory.

[johnnyholzeisen]

The answer is here : http://www.gigabyte.com.tw/Support/M...uctName=GA-6OX

Your mainboard doesn't support Pentium III Tualatin (130 nm technology)
The socket is the same as Coppermine's (180 nm), but the pinning is different.

EDIT :
How much would you sell your Pentium 3 - 1400 MHz ?

[juncon27]

Oh, my main not support it, I'll buy the other main.
Thankyou all of you for helping me .

Johnnyholzeisen, I don't sell it. But I buy it at a dirty shop which sell all of old things just for 10 USD .